This manual introduces how to use Holtek Flash MCU, including tool introduction, software and hardware instructions
This quick start manual (Rev. 1.00, dated 2017-08-04) from Holtek Semiconductor introduces the tools used to develop and program Holtek Flash MCUs. It is organized into a tool overview and a tool description covering both software and hardware.
The software section describes HT-IDE3000, the emulation development software for Holtek 8-bit MCUs, which with an OCDS EV chip supports single-step execution, full-speed execution, breakpoints and RAM monitoring, and HOPE3000, the writer software with erase, blank check, programming and verify functions plus partial and smart programming. The hardware section covers e-Link OCDS emulation using 4 pins (VDD, GND, OCDSCK, OCDSDA), e-Link ICP programming using 4 pins (VDD, GND, ICPCK, ICPDA), and e-WriterPro programming with HOPE3000 for engineering samples and mass production. This manual is written in Chinese.
| OCDS emulation connection pins | 4 pins: VDD, GND, OCDSCK, OCDSDA |
|---|---|
| ICP programming connection pins | 4 pins: VDD, GND, ICPCK, ICPDA |
HT-IDE3000 is the software designed for Holtek 8-bit MCU emulation development; used with an OCDS EV chip it supports single-step, full-speed, breakpoint setting and RAM monitoring.
HOPE3000 is writer software for Holtek 8-bit MCUs with erase, blank check, programming and verify functions, and it also supports partial programming and smart programming.
e-WriterPro works with HOPE3000 and supports online programming, offline programming and other methods, for engineering sample programming and mass production.