This manual describes the installation, use, diagnostics and maintenance of the Maxwell Ultracapacitor Engine Start Module (ESM).
This two-page quick installation guide from Maxwell covers the basic steps for installing the Engine Start Module (ESM), an ultracapacitor-based module that the document states is not a battery and must be treated differently. It opens with safety warnings about high current and arcing hazards, reverse polarity, and jump starting, then describes the mounting location.
The guide explains that the ESM is designed to mount in the same space as a Group 31 battery, typically in the battery box of a Class 6-8 truck, and lists the electrical connection steps in order. It closes with the initial charge procedure, using the Push-to-Test Button and status LEDs to confirm charging (flashing green) and full charge (solid green), and refers readers to the ESM INSTALLATION GUIDE and USER MANUAL for complete installation, diagnostics and support information.
| Mounting space | Same space as a Group 31 battery |
|---|---|
| Typical mounting location | Battery box of a Class 6-8 truck |
| Initial charge time | Up to 30 minutes |
| BATTERY (+) terminal | +12 V battery connection |
The ESM takes up to 30 minutes for an initial charge. A flashing green light after pressing the Push-to-Test Button means the ESM is charging.
After 30 minutes, pressing the Push-to-Test Button and seeing a solid green light means the ESM is fully charged and the engine can be started.
No. The guide warns not to connect any battery across the STARTER+ and BATTERY- terminals, as this will short the battery and cause arcing.
The ESM is designed to mount in the same space as a Group 31 battery, typically in the battery box of a Class 6-8 truck.