MAXWELL 1.28 Toilet 3-Inch Flush Valve Tank to Bowl Assembly Installation Guide

Installation instructions for assembling the tank to the bowl on the MAXWELL 1.28 toilet with a 3-inch flush valve.


MAXWELL 1.28 Toilet 3-Inch Flush Valve Tank to Bowl Assembly Installation Guide - cover page
Brand
Maxwell
Category
Other
Document type
Installation Guide
Language
English
Pages
1
File format
PDF
File size
967 KB
Published
08 November, 2026
Updated
08 November, 2026
Model
1.28
MD5 checksum
1F2120905745ACCEFCDBCB3E72339871

About this manual

This document gives directions for assembling the tank to the bowl on the MAXWELL 1.28 high-efficiency toilet with a 3-inch flush valve. Conventional fittings are used throughout so the working parts and operation are easy to understand.

Installation steps include checking lock nuts, fitting tank bolts with rubber washers and plastic wing nuts, placing channel pads, and tightening the wing nuts by hand. The guide also covers adjusting the water level to the marked line, inserting the refill tube into the overflow tube, and warns against using putty, pipe dope, or lubricants because overtightening may split the fill valve and void the warranty.

What's inside

  • Before assembling tank to bowl
  • Assemble tank bolts
  • Assemble bevel washer
  • Place channel pads
  • Place tank assembly in position
  • Plastic bolt caps and washers
  • Connect water supply line
  • Adjust water level
  • Refill tube and overflow tube
  • Check tank lever and flapper seal

Specifications

Flush valve size3 inch
Tank lever nut threadLeft hand thread
Replacement flapper assembly99-841
Replacement fill valve99-840
Parts bag number99-660

Frequently asked questions

Should putty be used when installing the tank?

No. Use no putty; all parts are supplied and the tank bolts are already sealed.

How should the plastic wing nuts be tightened?

Tighten them by hand sufficiently to compress the rubber washers and prevent the tank from rocking.

Can pipe dope or lubricants be used on the fill valve?

No. Use no pipe dope and hand tighten only, because overtightening may split the fill valve and void the warranty.

How much slack should the tank lever chain have?

There should be slight slack in the chain when it is at rest.

Download PDF (967 KB)

More Maxwell Manuals


View all Maxwell manuals →