This document describes the i.MX51 EVK Hardware User's Guide
This manual explains how to connect and operate the i.MX51 EVK system. It is written for software, hardware and system engineers who plan to use the product and want to understand more about it. The book starts with general information, top and bottom board views, a block diagram and a specifications table, then describes the main blocks of the board one by one.
The blocks covered include the i.MX51 processor, DDR II SDRAM, SPI NOR flash, the stereo audio codec and audio extension connector, touch screen controller, USB OTG and host, CMOS sensor, VGA and DVI out, LCD connectors, MMC/SD interface, fast Ethernet, FM and the power supply. Later sections describe the accessory boards (expansion card and LCD module card), boot mode setting and known issues.
| Clock | Selectable 32.768 kHz or 24 MHz |
|---|---|
| Operating temperature | -10 °C to +50 °C |
| Storage temperature | -40 °C to +85 °C |
| Relative humidity | 0 to 90% (noncondensing) |
| Power requirements | 5.0 V DC @ 3.8 A |
| Dimensions | 4.724 inch × 4.724 inch |
| DDR2 SDRAM | 128 MB × 4 DDR-2 (512 MB) |
| Boot flash | 4 MB SPI NOR (BOOT) |
The board requires 5.0 V DC at 3.8 A. The manual cautions that supplying more than +5.0 V can damage board components.
The operating range is -10 °C to +50 °C, with a storage range of -40 °C to +85 °C.
The board uses four 128 MB DDR-2 devices, for 512 MB in total.
The default LCD is the CPT 7” WVGA CLAA070VC01; the card is not included in the i.MX51 EVK kit.