This electronic drawing frame user manual introduces the making method, installation method, interactive control method of electronic drawing frame.
This is the Chinese user manual for the DFRobot 4Drawing electronic picture frame kit. It starts with the kit contents and the tools and materials needed, then walks through assembling the frame tray, box base and box cover, choosing where to hang the frame, and installing the electronic modules: the Palette main board (based on the ATmega32U4 and Arduino compatible), the battery box and the PIR motion sensor.
The second half covers placing and wiring the LED electronic sticker pieces on aluminum foil that serves as circuit ground, plus advanced builds that add sound effects and ambient light interaction. It ends with interaction control: plug-and-play use, graphical programming with Ardublock in the Arduino IDE (board type LilyPad Arduino USB), program upload, and free programming from the source code on GitHub. Safety notes warn about small parts, no water resistance, and a supply voltage limit of 5.5V. This manual is written in Chinese.
| Main board | Palette control board based on ATmega32U4, Arduino compatible |
|---|---|
| LED sticker pieces | Red, emerald green, orange-yellow, blue and white LEDs, two of each, plus one GND piece |
| Aluminum foil size | 278 mm long x 193 mm wide |
| Battery box | Holds 3 AA batteries |
| Cable set | About 22-24 Dupont-header wires, 15 cm long |
| Supported paper sizes | A4 and 9 x 12 inch |
| Maximum supply voltage | Higher than 5.5V may permanently damage the controller |
| Age warning | Not suitable for children 6 years old and under |
It uses a battery box that holds 3 AA batteries; the battery box connects to the control board's micro USB connector.
The tray supports A4 and 9 x 12 inch paper; smaller artwork can be used with an A4 cut-out mounting method.
In the Arduino IDE select the board type LilyPad Arduino USB, set the board switch to MAKE, connect it by micro-USB, then click "Upload to Arduino" in Ardublock.
The source code is available from the DFRobot 4Drawing GitHub repository, where you can modify or add Triggers and Actuators.