This user manual covers the DFRobot SEN0042 infrared fall detection sensor, including specifications, pin definitions, installation, and sample code.
The DFRobot SEN0042 is an infrared fall detection sensor designed for robots to detect stairs or steps and prevent falling. It utilizes a Sharp distance sensor with an effective measurement range of 10cm and provides a switch output. The sensor can also be used as a close-range obstacle avoidance sensor. This manual is written in Chinese.
| Operating Voltage | +2.7~6.2V |
|---|---|
| Operating Current | <10mA |
| Operating Temperature | 0℃~+70℃ |
| Interface Type | Three-wire (Signal, 5V, GND) |
| Detection Distance | 2-10cm (Low), <2cm or >10cm (High) |
| Module Dimensions | 36.0×10.0×15.0mm |
The sensor should be installed with a height less than 10cm from the ground.
Yes, the sensor can also be used as a close-range obstacle avoidance sensor.
Reverse connection will cause permanent damage to the module.