DFRobot FireBeetle Board-ESP32 User Manual

This manual provides user instructions for the DFRobot FireBeetle Board-ESP32, covering hardware features, Arduino IDE setup, and peripheral usage examples.


DFRobot FireBeetle Board-ESP32 User Manual - cover page
Brand
DFRobot
Category
Other Electronics
Document type
User Manual
Language
Chinese
Pages
49
File format
PDF
File size
1.6 MB
Published
28 October, 2026
Updated
28 October, 2026
MD5 checksum
101D3DA43A54AD19B900E5201D753CB5

About this manual

The DFRobot FireBeetle Board-ESP32 is a low-power IoT development platform based on the ESP32 SoC. It integrates WiFi and Bluetooth capabilities with a Tensilica LX6 dual-core processor, making it suitable for wearable electronics and mobile devices. The board supports USB and lithium battery power with a low-power mode consuming approximately 10uA. This manual is written in Chinese.

What's inside

  • Introduction
  • Quick Start
  • Hardware Features
  • Arduino IDE Setup
  • Serial Experiment
  • PWM Experiment
  • ADC Experiment
  • I2C Experiment
  • SPI Experiment
  • Deep Sleep Mode

Specifications

ProcessorTensilica LX6 Dual-core
Clock Speed240MHz
SRAM520KB
Flash Memory16Mbit
Low Power Mode10uA
Operating Voltage3.3V
Input Voltage Range4.2V~6V
Dimensions29.00 x 58.00 mm
Pin Spacing2.54mm
Operating Temperature-40℃~+85℃

Frequently asked questions

What is the low power consumption of the FireBeetle Board-ESP32?

The board supports a low-power mode with a consumption of approximately 10uA.

Which IDE is recommended for programming this board?

The manual recommends using Arduino IDE version 1.8.0 or higher.

What is the maximum charging current supported?

The board supports a maximum charging current of 500mA.

Does the board support Deep Sleep mode?

Yes, the board supports Deep Sleep mode, allowing it to sleep for a set time before restarting.

Download PDF (1.6 MB)

More DFRobot Manuals


View all DFRobot manuals →