This manual describes the hardware functionality and usage instructions for PerkinElmer instruments.
This manual provides instructions for using the PerkinElmer 263A Power Booster, an add-on system for electrochemical applications. It details how to connect the booster to a potentiostat and KEPCO power supply, configure settings, and perform initial checks. The manual includes safety warnings and specifications for different models (263A/10A, 263A/20A, 263A/8A).
| Rated Output Current | 20 A (nominal) for the 263A/20A system; 10 A for the 263A/10A system; and 8 A (nominal) for the 263A/8A system. |
|---|---|
| Rated Output Voltage | 20 V at 20 A (nominal) for the 263A/20A and 263A/10A; 50 V at 8 A (nominal) for the 263A/8A. |
| Bandwidth | 5 KHz at 3 db with 1 V applied at counter with 1-/G36 cell (1-W load) |
| Voltage Rise Time | <70 µs (10–90%, measured at Counter, ± 10 V/10-Hz square wave into a 1-W load, high-speed mode) |
| Potential Noise | <500 µV rms at E Monitor Out |
| Current Measurement Rise Time | <75µs (10–90%, measured at I Monitor Out, ±10 A/10-Hz square wave) |
| Current Measurement Accuracy | ±1% of reading, ± 20 mA |
| Applied Potential Accuracy | ±0.5% of reading, ±2 mV (nominal; determined by the KEPCO) |
The 263A/10A provides ±10 amps (nominal) at ±20 volts (nominal) compliance. The 263A/20A provides ±20 amps (nominal) at ±20 volts (nominal) compliance. The 263A/8A provides ±8 amps (nominal) at ±50 volts (nominal) compliance.
Connect the S-COM brown wire to S COM on the KEPCO rear panel and to screw-clamp connector 3 on the Power Booster Interface. Connect the S-OUT red wire to S OUT on the KEPCO rear panel and to screw-clamp connector 4 on the Power Booster Interface. Use the cardedge cable to connect the E/IN and I/OUT connectors.
The current measurement accuracy is ±1% of reading, ± 20 mA.
The applied potential accuracy is ±0.5% of reading, ±2 mV (nominal; determined by the KEPCO).