MoTeC MDC Mitsubishi Diff Controller User Manual

This document introduces the functionality, usage and installation methods of Mitsubishi Diff Controller (MDC).


MoTeC MDC Mitsubishi Diff Controller User Manual - cover page
Brand
Motec
Category
Vehicle maintenance
Document type
User Manual
Language
English
Pages
22
File format
PDF
File size
228 KB
Published
27 October, 2023
Updated
27 October, 2023
MD5 checksum
6AFB60E6C7FEFE101C2B28CA3BEAEA28

About this manual

This manual details the installation, configuration, and operation of the MoTeC MDC, a replacement for Mitsubishi’s Active Centre Diff controller. It covers mode selection, lock calculation, slip control, speed measurement, handbrake override, throttle calibration, steering position measurement, and hydraulic pump control. The MDC supports EVO7 to EVO9 models and can be configured via MDC Manager software for custom user modes and parameters.

The manual also explains CAN bus communication, ECU comms, fault codes, and pinout details, including setup for speed and throttle inputs, steering position, and hydraulic pressure control. It includes troubleshooting and priming procedures for hydraulic systems and explains how to manage configurations and monitor data via CAN messages.

What's inside

  • Introduction
  • MDC Functionality
  • Mode Selection
  • Lock Calculation
  • Slip Control
  • Speed Measurement
  • Handbrake Override
  • Throttle Calibration
  • Steering Position Measurement
  • Hydraulic Pressure Pump Control

Specifications

Supported Vehicle ModelsEVO7 to EVO9
Control ModesSix user-selectable modes (four configurable)
Speed MeasurementFour wheel speed sensors (direct or via ABS module)
Hydraulic Pump ControlMaintains pressure; protects pump from overuse

Frequently asked questions

How does slip control work?

Slip control detects rear speed vs front speed, calculates slip difference, and applies diff lock to maintain slip near the desired value from the Desired Slip table.

Which Mitsubishi EVO models are supported by the MDC?

The MDC is a direct replacement for the Active Centre Diff controller in Mitsubishi EVO7 to EVO9 vehicles and also supports centre diff control on Active Yaw Control equipped vehicles.

How long must the pump run without reaching the low pressure threshold before it shuts off?

The pump is turned off for 20 seconds if it has run for more than 20 seconds without achieving at least the low pressure threshold.

What is the maximum speed at which a wheel speed sensor reading is ignored?

If any wheel speed exceeds 300km/h, the sensor reading is ignored until its speed returns to below 300km/h for 2 seconds.

Download PDF (228 KB)

More Motec Manuals


View all Motec manuals →