Micrel KSZ8463/KSZ8863/73/KSZ9566/7/KSZ9897 Switch Usage Guide

This document is the user guide for Micrel Switch


Micrel KSZ8463/KSZ8863/73/KSZ9566/7/KSZ9897 Switch Usage Guide - cover page
Brand
Micrel
Category
Network Switches
Document type
Programming Manual
Language
English
Pages
44
File format
PDF
File size
324 KB
Published
19 October, 2023
Updated
19 October, 2023
MD5 checksum
46D3C8E57C22CB369C33CD825D7F8928

About this manual

This Micrel Switch Usage Guide, revision 1.0 dated October 30, 2014, describes how to modify a host network driver to support Micrel switch features. It lists the supported switches as KSZ8463, KSZ8863/73, KSZ9566/7, and KSZ9897 equivalents and notes that most switch drivers are Linux SPI drivers, with I2C drivers available if needed.

The guide covers the software driver implementation, Distributed Switch Architecture (DSA), host network driver modifications, switch APIs and PTP functions, hardware limitations, and the RSTP daemon. It explains that the switch is usually connected to a MAC controller through a MII/RGMII interface and is implemented as a Linux PHY device, with a virtual MDIO bus and PHY 0 for the whole switch.

What's inside

  • Introduction
  • Overview
  • Software Driver Implementation
  • Distributed Switch Architecture
  • Host Network Driver Modifications
  • Switch APIs
  • Switch Functions
  • PTP Functions
  • Hardware Limitations
  • RSTP Daemon

Specifications

Supported switchesKSZ8463, KSZ8863/73, KSZ9566/7, and KSZ9897 equivalents
Primary driver typeLinux SPI driver
Alternate driver interfaceI2C drivers available if needed
Host connectionMII/RGMII interface to a MAC controller
PHY mappingPHY 0 for the whole switch; PHY 1 for port 1; PHY 2 for port 2; and so on
Host portGenerally the last port of the switch

Frequently asked questions

Which Micrel switches are supported by this guide?

The guide covers KSZ8463, KSZ8863/73, KSZ9566/7 and KSZ9897 equivalents.

How is a Micrel switch usually connected to a MAC controller?

It is usually connected through a MII/RGMII interface.

What is the first step to make the Micrel switch work?

Make sure the MII interface is connected correctly on the system board and the correct MII mode is used.

What kernel configuration is defined when Micrel DSA support is selected?

CONFIG_NET_DSA_TAIL_TAG is defined when Micrel DSA support is selected.

Download PDF (324 KB)

More Micrel Manuals


View all Micrel manuals →