Endevco 2222C Microminiature Accelerometer Installation and Removal Guide

About this manual

This guide details how to install and remove the Endevco Model 2222C microminiature accelerometer. It specifies adhesives and solvents suitable for different temperature ranges, tools required, and critical precautions to prevent damage. For removal, a specific tool (P/N 2943B) must be used to break the bond by twisting. Cable replacement requires a clean, dry environment and proper torque (1 lbf-in).

What's inside

• Accessories, Adhesive, Solvent and Tools
• Special Precautions
• Mounting Procedure
• Removal Procedure
• Replacement of 3093 Cable Assembly

Frequently asked questions

What adhesives and solvents are recommended for mounting the 2222C?

For room temperature use: petro wax or bees wax. For up to 60°C: all-temperature glue stick and hot-melt glue gun with recommended solvent. For up to 125°C: cyanoacrylate (e.g., Loctite Super Bonder 430) with nitromethane base solvent (e.g., Loctite X-NMS Solvent 768).

What adhesive is recommended for use up to 125°C?

Cyanoacrylate, such as Loctite Super Bonder 430.

How long should the accelerometer be held in place after applying cement?

Press down and hold for 30 seconds while cement sets.

What torque value is recommended when tightening the cable connector?

About 1 lbf-in (~0.1 Nm) torque.