The document provides information about various branches of ROTRONIC AG and their contact details. It also includes details about the mechanical installation of the CRP1 clean room panel and mentions that humidity and temperature probes need to be ordered separately. The document does not mention the features and characteristics of the products.
This document provides installation instructions for the ROTRONIC CRP1 Series clean room panel, a device used to monitor and control essential parameters such as relative humidity and temperature in clean room environments. The panel measures these parameters with high precision using a separate HygroClip2 probe and features analog outputs, optional relays, and an RS-485 interface for MODBUS RTU communication.
The guide covers mechanical installation, including constructing a wall recess and mounting the wall bracket, as well as electrical connections for power supply, analog outputs, and the probe. It also details the programming of basic settings via the device menu, such as unit selection, alarm thresholds, and communication protocols, noting that detailed operation can be found in the full manual available online.
| Supply Voltage | 10...36 VDC |
|---|---|
| Current consumption | <500 mA |
| Resolution | 12 bit |
| Digital communication | RS-485 (MODBUS RTU / HW4) |
| Housing material | Steel 1.4401 / Plastic |
| Dimensions | 182 x 136 x 40 mm |
| IP protection | Front IP65 / Rear IP54 |
Yes, the humidity and temperature probes must be ordered separately.
The startup time is less than 15 seconds.
Yes, all device settings can be made with the help of the HW4 software and the AC3006 service cable.