The STE100P, also referred to as STEPHY1, is a high performance Fast Ethernet physical layer interface for 10BASE-T and 100BASE-TX applications. It was designed with advanced CMOS technology to provide a Media Independent Interface (MII) for easy attachment to 10/100 Media Access Controllers (MAC) and a physical media interface for 100BASE-TX of IEEE802.3u and 10BASE-T of IEEE802.3. The STEPHY1 supports both half-duplex and full-duplex operation, at 10 and 100 Mbps operation. Its operating mode can be set using auto-negotiation, parallel detection or manual control. It also allows for the support of auto-negotiation functions for speed and duplex detection.
The STE100P, also referred to as STEPHY1, is a high-performance Fast Ethernet physical layer interface designed for 10BASE-T and 100BASE-TX applications. It utilizes advanced CMOS technology to provide a Media Independent Interface (MII) for easy attachment to Media Access Controllers (MAC) and a physical media interface compliant with IEEE 802.3 standards. The device supports both half-duplex and full-duplex operation at 10 and 100 Mbps, with operating modes configurable via auto-negotiation, parallel detection, or manual control.
| Operating Speeds | 10 and 100 Mbps |
|---|---|
| Interface Standard | 100BASE-TX and 10BASE-T |
| Package Type | 64-pin QFP |
| Reference Clock Frequency | 25 MHz |
| Supply Voltage | 3.3V |
The STE100P is also referred to as STEPHY1.
The reset input must be held low for a minimum of 1 ms.