This document is the user guide for the ADCLK944 evaluation board, which describes how to set up and use the evaluation board. The ADCLK944 is a high-performance clock fanout buffer fabricated using high-quality Rogers dielectric material. The document also provides the recommended board setup and schematic of the evaluation board.
This user guide explains how to set up and use the ADCLK944 evaluation board. The board is fabricated using high-quality Rogers dielectric material, with transmission line paths kept as close to 50 Ω as possible. It is designed for the ADCLK944, a very high performance clock fanout buffer.
| Input Voltage Swing | 0.2 V p-p to 1.7 V p-p |
|---|---|
| Power Supply Voltage | 2.5 V to 3.3 V |
| Output Bias | Biased to GND via 200 Ω |
The recommended setup uses VCC set to 2.5 V to 3.3 V, VEE set to GND, and includes a single power supply, signal source, high bandwidth oscilloscope, and matched high speed cables.
The basic equipment required includes one single power supply, one signal source, one high bandwidth oscilloscope, and four matched high speed cables.