This application note provides basic information about the SSM2167 evaluation board, including connections and setup methods. The evaluation board supports 3V power and can be connected to a power supply or 2 AA batteries through JP3.
The document provides a guide for evaluating the SSM2167 audio compression chip using its dedicated evaluation board. It details basic connections for power, ground, input signals (electret or dynamic microphones), and output signals to an amplifier.
The text outlines a five-step testing procedure: establishing connections, verifying setup with specific jumper settings and signal levels, conducting listening tests, adjusting noise-gate thresholds, and modifying compression ratios. It also includes schematics, layout diagrams, and a complete parts list for the board.
| Operating Voltage | 3 V (optimized) |
|---|---|
| Input Jack Type | 3.5 mm stereo sockets |
| Electret Bias Resistor | 2.2 kΩ (R4) |
Connect the SHUTDOWN pin on JP3 directly to ground.
Yes, but you must remove resistor R4 which is used for electret biasing.
A 2:1 ratio is recommended for initial evaluation.