This reference circuit contains an ultra-low noise analog MEMS microphone and a microphone preamp with 18dB fixed gain.
This Circuit Note presents a design that interfaces an analog MEMS microphone to a microphone preamp. The circuit utilizes the ADMP504, which consists of a MEMS microphone element and an output amplifier, connected to the SSM2167 low voltage, low noise mono microphone preamp. The design leverages built-in compression and noise gating features of the preamp to improve voice signal intelligibility.
| Microphone Sensitivity | -38 dBV |
|---|---|
| Microphone Dynamic Range | 91 dB |
| Microphone Noise Floor | -103 dBV |
| Preamp Supply Voltage | 2.5 V to 3.3 V |
| Preamp Fixed Gain | 18 dB |
| Preamp Max Compression Ratio | 10:1 |
| Microphone SNR | 65 dB |
The circuit uses an ADMP504 analog MEMS microphone connected to an SSM2167 low noise mono microphone preamp.
With a 0.1 uF coupling capacitor and 100 kΩ input impedance, the high-pass filter's corner is 16 Hz.
Yes, the circuit can be set up with the SSM2166 instead of the SSM2167, though the SSM2166 is more flexible and expensive.