The system detected an error in the robot calibration file stored in memory. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, initialize the file for calibration between manipulators in maintenance mode, and then load the file for calibration between manipulators saved in the external memory device.”
- Model
- Yaskawa FS100
- Display shows
- MEMORY ERROR (ROBOT CALIB FILE) (4014)
- Type
- Alarm code
- Source
- Manual p. 155
What 4014 means
MEMORY ERROR (ROBOT CALIB FILE) p. 155
Common causes
- Data error p. 155
What to do
- (1)Reset the alarm. (2)If the alarm occurs again, initialize the file for calibration between manipulators in maintenance mode, and then load the file for calibration between manipulators saved in the external memory device. p. 155
If 4014 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.
This page summarises what the manufacturer’s manual says about 4014; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.