Fault code5
Charging switch fault occurs when the charging switch is open during start command or due to an operation malfunction with a defective component. The manual's first action is: “Reset the fault and start the drive again. If the fault shows again, ask instructions from the distributor near to you.”
- Model
- Vacon NXS/P
- Display shows
- Charging switch (5)
- Type
- Fault code
- Source
- Manual p. 150
What 5 means
Charging switch p. 150
Common causes
- The charging switch is open, when the START command is given. p. 150
- operation malfunction defective component p. 150
What to do
- Reset the fault and start the drive again. If the fault shows again, ask instructions from the distributor near to you. p. 150
Before you service the product, read the safety instructions in the manual p. 13.
If 5 is still not resolved
- Contact service or dealer for assistance. p. 13 “WARNING! Before you do electrical work, make sure that there is no voltage in the components of the drive.”
- Contact service or dealer for assistance. p. 14 “CAUTION! Do not touch the components on the circuit boards. Static voltage can cause damage to these components.”
This page summarises what the manufacturer’s manual says about 5; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Vacon. Found a mistake? Report an error.