Fault codeF30015
A phase failure was detected in the motor feeder cable, possibly causing unstable closed-loop control and oscillating torque. The manual's first action is: “Check the motor feeder cables.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Phase failure motor cable (F30015)
- Type
- Fault code
- Source
- Manual p. 300
What F30015 means
Phase failure motor cable p. 300
Common causes
- A phase failure in the motor feeder cable was detected. p. 300
- The signal can also be output in the following case: The motor is correctly connected, however the closed-speed control is unstable and therefore an oscillating torque is generated. p. 300
What to do
Before you service the product, read the safety instructions in the manual p. 2.
If F30015 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F30015; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.