Alarm codeA7965
Save required because the angular commutation offset was re-defined but not saved permanently. The manual's first action is: “This alarm automatically disappears after the data has been saved.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Save required (A7965)
- Type
- Alarm code
- Source
- Manual p. 311
What A7965 means
Save required p. 311
Common causes
- The angular commutation offset was re-defined and has still not been saved. In order to permanently accept the new value, it must be saved in a non-volatile fashion. p. 311
What to do
- This alarm automatically disappears after the data has been saved. p. 311
Before you service the product, read the safety instructions in the manual p. 2.
If A7965 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about A7965; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.