Alarm codeA7441
The absolute encoder adjustment offset has been saved, triggering this alarm as a status change notification. The manual's first action is: “Not necessary. This alarm automatically disappears after the offset has been saved. See also: p2525 (LR encoder adjustment offset)”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- A7441
- Type
- Alarm code
- Source
- Manual p. 306
What A7441 means
LR: Save the position offset of the absolute encoder adjustment p. 306
Common causes
- The status of the absolute encoder adjustment has changed. p. 306
What to do
- Not necessary. This alarm automatically disappears after the offset has been saved. See also: p2525 (LR encoder adjustment offset) p. 306
Before you service the product, read the safety instructions in the manual p. 2.
If A7441 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about A7441; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.