Siemens SINAMICS V90, SIMOTICS S-1FL6 Error A30016: Load supply switched off

Industrial motor drive · taken from the manufacturer’s manual, pages cited

Fault codeA30016

Load supply switched off because the DC link voltage is too low. The manual's first action is: “Switch on the load supply.”

Model
Siemens SINAMICS V90, SIMOTICS S-1FL6
Display shows
Load supply switched off (A30016)
Type
Fault code
Source
Manual p. 312

What A30016 means

Load supply switched off p. 312

Common causes

  • The DC link voltage is too low. p. 312

What to do

  1. Switch on the load supply. p. 312
  2. Check the line supply if necessary. p. 312

Before you service the product, read the safety instructions in the manual p. 2.

If A30016 is still not resolved

  • Contact service / dealer for assistance p. 2
    “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
  • Contact service / dealer for assistance p. 13
    “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
Open the manual at page 312 All SINAMICS V90, SIMOTICS S-1FL6 error codes Manual details & download

This page summarises what the manufacturer’s manual says about A30016; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.