Siemens S5-115U Error KOLIF: Interprocessor communication flag transfer list is incorrect.

Siemens S5-115U Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeKOLIF

Interprocessor communication flag transfer list is incorrect due to DB1 programming error. The manual's first action is: “Check the following: • ID for interprocessor communication flag definitions ("MASK01")(see Section 12.1) • ID for the part of DB1 to be interpreted ("DB1") (see Section 11.3) • the end IDs in each case for interprocessor communication flag definitions or for the part of DB1 to be interpreted”

Model
Siemens S5-115U
Display shows
KOLIF
Type
Error code
Source
Manual p. 138

What KOLIF means

Interprocessor communication flag transfer list is incorrect. p. 138

Common causes

  • DB1 is programmed incorrectly. p. 138
  • Interprocessor communication flag transfer list is incorrect. p. 138

What to do

  1. Check the following: • ID for interprocessor communication flag definitions ("MASK01")(see Section 12.1) • ID for the part of DB1 to be interpreted ("DB1") (see Section 11.3) • the end IDs in each case for interprocessor communication flag definitions or for the part of DB1 to be interpreted p. 138

Before you service the product, read the safety instructions in the manual p. 414.

If KOLIF is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.

Open the manual at page 138 All S5-115U error codes Manual details & download

This page summarises what the manufacturer’s manual says about KOLIF; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.