Siemens S5-115U Error STS: Operation interrupted by a programmer STOP request or programmed STOP statements.

Siemens S5-115U Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeSTS

Operation interrupted by a programmer STOP request or programmed STOP statements. The manual lists no action for this code.

Model
Siemens S5-115U
Display shows
STS
Type
Error code
Source
Manual p. 139

What STS means

Operation interrupted by a programmer STOP request or programmed STOP statements. p. 139

Common causes

  • - Software stop by statement (STP, STS) - STOP request from programmer - STOP request from SINEC L1 master p. 139
  • Operation interrupted by a programmer STOP request or programmed STOP statements. p. 139

If STS is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.

Open the manual at page 139 All S5-115U error codes Manual details & download

This page summarises what the manufacturer’s manual says about STS; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.