Siemens S5-115U Error TRAF: Transfer error for data block statements: data word number >data block length.

Siemens S5-115U Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeTRAF

Transfer error for data blocks because the data word number exceeds the data block length or DB not opened. The manual's first action is: “Correct the program error.”

Model
Siemens S5-115U
Display shows
TRAF
Type
Error code
Source
Manual p. 139

What TRAF means

Transfer error for data block statements: data word number >data block length. p. 139

Common causes

  • - Transfer error: - A data block statement has been programmed with data word number greater than the data block length. - A data block statement has been programmed without opening a DB first. - DB to be generated is too long for user memory (G DB operation) p. 139
  • Transfer error for data block statements: data word number >data block length. p. 139

What to do

  1. Correct the program error. p. 139

Before you service the product, read the safety instructions in the manual p. 414.

If TRAF is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.

Open the manual at page 139 All S5-115U error codes Manual details & download

This page summarises what the manufacturer’s manual says about TRAF; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.