Shihlin Electric SDA Series Error AL. 09: Abnormal serial communication

AC servo system · taken from the manufacturer’s manual, pages cited

Alarm codeAL. 09

AL.09 means there's an error in the communication protocol setup causing serial communication failure. The manual's first action is: “Power OFF→ON”

Model
Shihlin Electric SDA Series
Display shows
Abnormal serial communication (AL. 09)
Type
Alarm code
Source
Manual p. 198

What AL. 09 means

Abnormal serial communication p. 229

Common causes

  • Communication protocol setup error p. 229

What to do

  1. Power OFF→ON p. 229
  2. Press SET at the current alarm screen p. 229
  3. Alarm reset (RES) signal p. 229
  4. Check if the communication protocol set value matches. p. 229

If AL. 09 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Shihlin Electric service.

This page summarises what the manufacturer’s manual says about AL. 09; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Shihlin Electric. Found a mistake? Report an error.