Sanyo Machine Works SDNR Error F2: RS232C PORT TRANSMISSION ERROR

AC Servo Nutrunner · taken from the manufacturer’s manual, pages cited

Error codeF2

RS232C PORT TRANSMISSION ERROR occurs when the communication cable or its connection is wrong, or the reception process is too slow. The manual's first action is: “Check the connection of the communication cable. Replace the cable if the trouble occurs after confirming the connection.”

Model
Sanyo Machine Works SDNR
Display shows
RS232C PORT TRANSMISSION ERROR (F2)
Type
Error code
Source
Manual p. 109

What F2 means

RS232C PORT TRANSMISSION ERROR p. 146

Common causes

  • Communication cable or its connection is wrong. p. 146
  • Reception process is too slow. p. 146

What to do

  1. Check the connection of the communication cable. Replace the cable if the trouble occurs after confirming the connection. p. 146
  2. Speed up the transmission process. p. 146

Before you service the product, read the safety instructions in the manual p. 65.

If F2 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Sanyo Machine Works service.

Open the manual at page 109 All SDNR error codes Manual details & download

This page summarises what the manufacturer’s manual says about F2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Sanyo Machine Works. Found a mistake? Report an error.