Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The system encountered a syntax error in its operation. The manual lists no action for this code.
The system detected an error in the data checksum. The manual lists no action for this code.
Transmission error with the media has occurred. The manual's first action is: “Framing error”
The controller detected an error in the media input/output system. The manual lists no action for this code.
The code 3070 indicates an issue with the number of files on the media. The manual lists no action for this code.
The media is out of memory. The manual lists no action for this code.
The system has saved a file to the media. The manual lists no action for this code.
The file was not saved to the media storage. The manual lists no action for this code.
The system indicates that a USB media device is not inserted. The manual lists no action for this code.
The CompactFlash memory card is not inserted into its slot. The manual lists no action for this code.
The system detected an error in the mechanical limit pulse setting. The manual's first action is: “(1)Check the following settings. - Check the position setting for the step (move instruction) where the alarm occurred.”
The system has reached a pulse limit at the destination position. The manual's first action is: “(1)Check the following settings. - Check the position setting for the step (move instruction) where the alarm occurred.”
The system detected a collision due to an incorrect setting. The manual's first action is: “Confirm the settings of the followings. -Work”
The converter is generating excessive regenerative power that exceeds its limits. The manual's first action is: “Correct the converter primary power supply.”
The DIN signal settings have been set incorrectly. The manual's first action is: “Confirm the DIN signal settings.”