Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The lamp has reached its maximum runtime of 3,000 hours. The manual's first action is: “It has reached the lamp replacement time. Replace the lamp unit.”
The lamp has reached its maximum runtime of 3,000 hours. The manual's first action is: “It has reached the lamp replacement time. Replace the lamp unit.”
The lamp is not lighting due to a fault. The manual's first action is: “Failed to light the lamp. Turn on the power again after the lamp is cooled. If the lamp still does not light, consult your dealer.”
The lamp has failed and is not lighting. The manual's first action is: “Failed to light the lamp. Turn on the power again after the lamp is cooled. If the lamp still does not light, consult your dealer.”
The lamp is not lighting due to a fault. The manual's first action is: “Failed to light the lamp. Turn on the power again after the lamp is cooled. If the lamp still does not light, consult your dealer.”
The lamp has failed and is not lighting. The manual's first action is: “Failed to light the lamp. Turn on the power again after the lamp is cooled. If the lamp still does not light, consult your dealer.”
The lamp has reached its recommended replacement time. The manual's first action is: “It will reach the lamp replacement time. Replace the lamp unit.”
The lamp has reached its recommended replacement time. The manual's first action is: “It will reach the lamp replacement time. Replace the lamp unit.”
The lamp has reached its recommended replacement time. The manual's first action is: “It will reach the lamp replacement time. Replace the lamp unit.”
The lamp has reached its recommended replacement time. The manual's first action is: “It will reach the lamp replacement time. Replace the lamp unit.”
The projector has detected a lamp that is not compatible with its system. The manual's first action is: “Replace the lamp unit with one compatible with the projector.”
A different type of lamp unit is attached. The manual's first action is: “A different type of lamp unit is attached. Check the model number displayed on the lamp unit and use a lamp unit with the same model number.”
The projector has detected a used lamp unit. The manual's first action is: “To install in portrait, use the Replacement lamp unit (for portrait mode).”
The projector has detected an incorrect portrait installation angle. The manual's first action is: “Install the projector with the connecting terminals down.”
The projector is not installed at an angle within the allowed ±15° range from horizontal. The manual's first action is: “Use the projector at an angle not exceeding ±15° from the horizontal plane.”