Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A COP, CPW, or FLL instruction length parameter references outside of the entire data space. The manual's first action is: “Correct the program to ensure that the length and parameter do not point outside of the data …
A BSR or BSL instruction length parameter is greater than 2048 or an FFL, FFL, LFU, LFL instruction length parameter is greater than 128 (word file) or greater than 64 (double word file). The manual's first action is:…
A sequencer instruction (S00, SOC, SOL) length/position parameter is greater than 255. The manual's first action is: “Correct the user program, then recompile, reload the program, and enter the Run mode.”
An error occurred in the PWMX instruction configuration. The manual's first action is: “See the Error Code in the PWMX Function File for the specific error.”
An error occurred in the PTOX instruction configuration. The manual's first action is: “See the Error Code in the PTOX Function File for the specific error.”
An error occurred in the HSC configuration. The manual's first action is: “See the Error Code in the HSC Function File for the specific error.”
An invalid value is being used for a PID parameter. The manual's first action is: “See Process Control Instruction on page 221 for more information about the PID instruction.”
The program contains a Temporary End (TND), Refresh (REF), or Service Communication Instruction in an interrupt subroutine (STI, EII, HSC) or user fault routine. The manual's first action is: “['Correct the program.',…
A negative value was loaded to a timer preset or accumulator. The manual's first action is: “['If the program is moving values to these accumulated or preset word of a timer, verify these values are not negative.', 'R…
The length/position parameter of a BSL, BSR, FFL, FFU, LFL, or LFU instruction references outside of the entire data file space. The manual's first action is: “['Correct the program to ensure that the length and posit…
A sequencer instruction length/position parameter references outside of the entire data file space. The manual's first action is: “['Correct the program to ensure that the length and position parameters do not point o…
The program contains an instruction that the controller does not support. The manual's first action is: “['Modify the program so that the controller supports all instructions.', 'Recompile and reload the program and e…
The JSR instruction nesting level exceeded the controller memory space. The manual's first action is: “['Correct the user program to reduce the nesting levels that are used and to meet the restrictions for the JSR ins…
An error occurred in the EII configuration. The manual's first action is: “See the Error Code in the EII Function File for the specific error.”
DNP3 event configuration (S:36/11) bit in the latest downloaded by user project differs from the power-up configuration. The manual's first action is: “['Cycle power for the new DNP3 configuration to take effect and e…