Error Codes

Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.

• CodeTECSYSTEM NT538 Error ECH: eeprom fault

  The ECH code indicates an EEPROM fault. The manual's first action is: “erased message”

• Code listTECSYSTEM NT538 Error Codes

  All 16 error codes of the TECSYSTEM NT538 TECSYSTEM NT538 with their meaning, causes and what to do, taken from the manufacturer's manual with page references.

• CodeKT KT-LCD 10Y Error 06_info: Motor or controller has short circuit Abnormality

  Motor or controller has short circuit Abnormality The manual lists no action for this code.

• CodeKT KT-LCD 10Y Error 05_info: Axis speed sensor Abnormality(only applied to torque sensor )

  Axis speed sensor Abnormality(only applied to torque sensor ) The manual lists no action for this code.

• CodeKT KT-LCD 10Y Error 04_info: Torque sensor Signal Abnormality

  Torque sensor Signal Abnormality indicates a problem with the torque sensor. The manual lists no action for this code.

• CodeKT KT-LCD 10Y Error 03_info: Motor Hall Signal Abnormality

  Motor Hall Signal Abnormality indicates a problem with motor signal detection. The manual lists no action for this code.

• CodeKT KT-LCD 10Y Error 01_info: Throttle Abnormality

  Throttle Abnormality indicates an issue with the throttle system. The manual lists no action for this code.

• Code listKT KT-LCD 10Y Error Codes

  All 5 error codes of the KT KT-LCD 10Y KT KT-LCD 10Y with their meaning, causes and what to do, taken from the manufacturer's manual with page references.

• CodeRosemount 370XA Error 9.1.29: Stored Data Integrity Failure

  The stored data integrity has failed due to a mismatch in the CRC code during retrieval. The manual's first action is: “If there is a mismatch, then this alarm is generated.”

• CodeRosemount 370XA Error 9.1.28: Calibration Energy Value Check Fail

  The calculated energy value from calibration analysis does not match the certified energy value. The manual lists no action for this code.

• CodeRosemount 370XA Error 9.1.27: Stream 4 RF Out Of Order

  Stream 4 RF is out of order due to incorrect thermal conductivity response factor ordering for natural gas applications. The manual lists no action for this code.

• CodeRosemount 370XA Error 9.1.26: Stream (1, 2, or 3) Out Of Order

  Stream (1, 2, or 3) Out Of Order indicates streams should be set to Analysis or Unused only. The manual lists no action for this code.

• CodeRosemount 370XA Error 9.1.25: Energy Value Invalid

  The GC has computed an invalid energy value for the calibration gas. The manual's first action is: “The GC then compares this value to the Cal Gas Cert CV and determines if the calibration gas's energy value is within…

• CodeRosemount 370XA Error 9.1.24: IMB CDT Component is missing in GC

  The GC's component data table does not match the replacement module's component data table. The manual's first action is: “The component data table of the GC must match (with the exception of neo-pentane) the componen…

• CodeRosemount 370XA Error 9.1.16: Stream 4 RF Deviation

  Stream 4 RF Deviation code indicates a calibration run changed component response factor by more than the set percentage. The manual lists no action for this code.