Error codeTimeOut!
The system has detected that the hydraulic cylinder has reached its end of stroke while still attempting to move further in that direction, or the boom is moving too slowly or lacks sufficient hydraulic pressure. The manual's first action is: “Follow 4.3.2 a.”
- Model
- NORAC UC4
- Display shows
- TimeOut! (TimeOut!)
- Type
- Error code
- Source
- Manual p. 24
What TimeOut! means
TimeOut! p. 24
Common causes
- a. Hydraulic cylinder has reached the end of its stroke, but the system is still trying to move in that direction. p. 24
- b. Boom is moving too slow. p. 24
- c. There is not enough hydraulic pressure to move the boom. p. 24
- d. If the boom was moving before this message appeared, this is probably not an error of concern. p. 24
What to do
- Follow 4.3.2 a. p. 24
- Follow 4.3.2 b. p. 24
- Follow 4.3.2 c. p. 24
- Some booms will take longer than others to calibrate, triggering a "TimeOut!". p. 24
Before you service the product, read the safety instructions in the manual p. 5.
If TimeOut! is still not resolved
- contact service / dealer p. 5 “Refer to the warranty statement in Section 0 for more details.”
This page summarises what the manufacturer’s manual says about TimeOut!; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with NORAC. Found a mistake? Report an error.