NORAC UC4 Error MA 35

Sprayer · taken from the manufacturer’s manual, pages cited

Error codeMA 35

The sensor is reading a target too close (less than 7 inches) or is contaminated, or moisture has entered the sensor. The manual's first action is: “Follow 4.2.3 a).”

Model
NORAC UC4
Display shows
MA 35
Type
Error code
Source
Manual p. 26

What MA 35 means

Sensor is out of range or reading a target closer than 7". p. 26

Common causes

  • Sensor is out of range or reading a target closer than 7". p. 26
  • Protective foam shield is contaminated. p. 26
  • Moisture in sensor. p. 26
  • Transducer is damaged or contaminated. p. 26
  • Serial number entered in control panel does not match connected sensor. p. 26
  • Poor cable connection or defective cable(s). p. 26
  • Damaged sensor. p. 26

What to do

  1. Follow 4.2.3 a). p. 26
  2. Follow 4.2.3 b). p. 26
  3. Follow 4.2.3 d-1), d:2). p. 26
  4. Follow 4.2.3 e). p. 26
  5. Follow 4.2.1 a). p. 26
  6. Follow 4.2.1 b). p. 26
  7. Follow 4.2.1 c). p. 26

Before you service the product, read the safety instructions in the manual p. 5.

If MA 35 is still not resolved

  • contact service / dealer p. 5
    “Refer to the warranty statement in Section 0 for more details.”
Open the manual at page 26 All UC4 error codes Manual details & download

This page summarises what the manufacturer’s manual says about MA 35; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with NORAC. Found a mistake? Report an error.