Marantec Synergy 260, 270 Error 7

Garage door operator · taken from the manufacturer’s manual, pages cited

Fault code7

The door does not move easily or is obstructed due to programming mode termination or incorrect door position programming. The manual lists no action for this code.

Model
Marantec Synergy 260, 270
Display shows
7
Type
Fault code
Source
Manual p. 31

What 7 means

NOTICE: ■ If no buttons are pressed within 120 seconds, the programming mode terminates automatically. ■ OPEN and CLOSED door positions programmed without passing the reference point. p. 31

Common causes

  • NOTICE: ■ If no buttons are pressed within 120 seconds, the programming mode terminates automatically. ■ OPEN and CLOSED door positions programmed without passing the reference point. p. 31

If 7 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Marantec service.

This page summarises what the manufacturer’s manual says about 7; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Marantec. Found a mistake? Report an error.