Marantec Synergy 260, 270 Error 28

Garage door operator · taken from the manufacturer’s manual, pages cited

Fault code28

Door movement is too stiff, irregular, or blocked due to sensitivity settings being too low; check for obstructions, balance, or broken springs and have it serviced if needed. The manual's first action is: “Check door for obstructions, proper manual operation, proper balance, or broken springs. Clear obstructions or have door serviced, if needed.”

Model
Marantec Synergy 260, 270
Display shows
28
Type
Fault code
Source
Manual p. 31

What 28 means

Door movement too stiff or irregular. p. 31

Common causes

  • Door movement too stiff or irregular. p. 31
  • Door blocked. p. 31
  • Operator operating sensitivity set too sensitive (low). p. 31

What to do

  1. Check door for obstructions, proper manual operation, proper balance, or broken springs. Clear obstructions or have door serviced, if needed. p. 31
  2. Have the operating sensitivity settings checked by an authorized dealer/installer d. p. 31

Before you service the product, read the safety instructions in the manual p. 3.

If 28 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Marantec service.

This page summarises what the manufacturer’s manual says about 28; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Marantec. Found a mistake? Report an error.