Marantec Synergy 260, 270 Error 16: The current sensor for the automatic cut-out is defective

Garage door operator · taken from the manufacturer’s manual, pages cited

Fault code16

The current sensor for automatic cut-out is defective; have the operator serviced. The manual's first action is: “Have operator serviced.”

Model
Marantec Synergy 260, 270
Display shows
The current sensor for the automatic cut-out is defective (16)
Type
Fault code
Source
Manual p. 31

What 16 means

The current sensor for the automatic cut-out is defective p. 31

Common causes

  • The current sensor for the automatic cut-out is defective. p. 31

What to do

  1. Have operator serviced. p. 31

Before you service the product, read the safety instructions in the manual p. 3.

If 16 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Marantec service.

This page summarises what the manufacturer’s manual says about 16; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Marantec. Found a mistake? Report an error.