Photo eye sensors are not connected properly, misaligned, or the beam is broken; check wiring and alignment of photo eyes. The manual's first action is: “Check photo eye sensors wiring and connections.”
- Model
- Marantec Synergy 260, 270
- Display shows
- 15
- Type
- Fault code
- Source
- Manual p. 31
What 15 means
Photo eye sensors not connected properly. p. 31
Common causes
- Photo eye sensors not connected properly. p. 31
- Photo eye sensors not aligned. p. 31
- Obstruction in the door path (photo eye beam broken). p. 31
What to do
- Check photo eye sensors wiring and connections. p. 31
- Realign photo eye sensors. p. 31
- Remove obstruction from door path. p. 31
Before you service the product, read the safety instructions in the manual p. 3.
If 15 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Marantec service.
This page summarises what the manufacturer’s manual says about 15; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Marantec. Found a mistake? Report an error.
