INVT DA180 Error Er25-9: Application fault– Overtail/overspeed in confirmation of magnetic pole check

AC servo drive · taken from the manufacturer’s manual, pages cited

Fault codeEr25-9

Application fault– Overtail/overspeed in confirmation of magnetic pole check occurs when motor motion range is too large or speed is too fast during magnetic pole check, requiring P6.70 adjustment. The manual's first action is: “Increase the setting of P6.70.”

Model
INVT DA180
Display shows
Er25-9
Type
Fault code
Source
Manual p. 275

What Er25-9 means

Application fault– Overtail/overspeed in confirmation of magnetic pole check p. 275

Common causes

  • The motor motion range is too large or speed is too fast in the confirmation of magnetic pole. p. 275

What to do

  1. Increase the setting of P6.70. p. 275

If Er25-9 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact INVT service.

Open the manual at page 275 All DA180 error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er25-9; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with INVT. Found a mistake? Report an error.