INVT DA180 Error Er19-3: Speed fault—Overspeed parameter set incorrectly

AC servo drive · taken from the manufacturer’s manual, pages cited

Fault codeEr19-3

Speed fault—Overspeed parameter set incorrectly occurs when P4.40 is less than 0 or P4.41 is greater than 0. The manual's first action is: “7180-1303h”

Model
INVT DA180
Display shows
Speed fault—Overspeed parameter set incorrectly (Er19-3)
Type
Fault code
Source
Manual p. 258

What Er19-3 means

Speed fault—Overspeed parameter set incorrectly p. 258

Common causes

  • The setting of P4.40 is less than 0 or that of P4.41 is greater than 0. p. 258

What to do

  1. 7180-1303h p. 258
  2. 1. Ensure the encoder is connected properly. 2. P4.40 or P4.41 is set incorrectly. p. 258

If Er19-3 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact INVT service.

Open the manual at page 258 All DA180 error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er19-3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with INVT. Found a mistake? Report an error.