Heraeus UT6P, UT12P, UT20P Error stop: Termination command when entering the programmed controller function: the heating and ventilation is switched off on termination of the program

Laboratory air circulation oven · taken from the manufacturer’s manual, pages cited

Error codestop

Termination command shuts off heating and ventilation when ending a programmed function on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.

Model
Heraeus UT6P, UT12P, UT20P
Display shows
stop
Type
Error code
Source
Manual p. 17

What stop means

Termination command when entering the programmed controller function: the heating and ventilation is switched off on termination of the program p. 17

If stop is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Heraeus service.

This page summarises what the manufacturer’s manual says about stop; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Heraeus. Found a mistake? Report an error.