Heraeus UT6P, UT12P, UT20P Error CYCL: Termination command when entering the programmed controller function: when the program is terminated, it returns to the beginning and starts again

Laboratory air circulation oven · taken from the manufacturer’s manual, pages cited

Error codeCYCL

Termination command restarts the program from the beginning when ending a programmed function on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.

Model
Heraeus UT6P, UT12P, UT20P
Display shows
CYCL
Type
Error code
Source
Manual p. 17

What CYCL means

Termination command when entering the programmed controller function: when the program is terminated, it returns to the beginning and starts again p. 17

If CYCL is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Heraeus service.

This page summarises what the manufacturer’s manual says about CYCL; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Heraeus. Found a mistake? Report an error.