Heraeus UT6P, UT12P, UT20P Error P1.3: Program segment when entering an added-feature program function

Laboratory air circulation oven · taken from the manufacturer’s manual, pages cited

Error codeP1.3

Program segment is active while the added-feature program is running on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.

Model
Heraeus UT6P, UT12P, UT20P
Display shows
P1.3
Type
Error code
Source
Manual p. 17

What P1.3 means

Program segment when entering an added-feature program function p. 17

If P1.3 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Heraeus service.

This page summarises what the manufacturer’s manual says about P1.3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Heraeus. Found a mistake? Report an error.