Heraeus UT6P, UT12P, UT20P Error hold: Termination command when entering the programmed controller function: the temperature set for the last program segment is maintained on termination of the program

Laboratory air circulation oven · taken from the manufacturer’s manual, pages cited

Error codehold

Termination command holds the last set temperature when ending a programmed function on this Heraeus UT6P, UT12P, or UT20P unit. The manual lists no action for this code.

Model
Heraeus UT6P, UT12P, UT20P
Display shows
hold
Type
Error code
Source
Manual p. 17

What hold means

Termination command when entering the programmed controller function: the temperature set for the last program segment is maintained on termination of the program p. 17

If hold is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Heraeus service.

This page summarises what the manufacturer’s manual says about hold; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Heraeus. Found a mistake? Report an error.