Fujitsu General 410A Error 95: Compressor control error

Fujitsu General 410A · taken from the manufacturer’s manual, pages cited

Error code95

Compressor Motor Control Error if rotor location is out of phase more than 90 degrees The manual's first action is: “After the compressor restarts, if the same operation is repeated within 40 seconds, the compressor stops again.”

Model
Fujitsu General 410A
Display shows
Compressor control error (95)
Type
Error code
Source
Manual p. 11

What 95 means

Compressor control error p. 11

Common causes

  • Compressor Motor Control Error – If the detected rotor location is out of phase with actual rotor location more than 90 degrees, the compressor stops. p. 11
  • -Check if connector is removed. p. 11
  • -Check if cable is open. p. 11
  • Compressor Motor Control Error - If the detected rotor location is out of phase with actual rotor location more than 90 degrees, the compressor or stops. After the same operation restarts, if the same operation is repeated within 40 seconds, the compressor stops again. p. 11

What to do

  1. After the compressor restarts, if the same operation is repeated within 40 seconds, the compressor stops again. p. 11
  2. (Ref. Service Tip #060-Compressor Check and/or "Fan Motor Error" under “Compressor Control / Compressor Location Error” Type In Zendesk Help Center) p. 11
  3. -Check connector is removed. -Check erroneous connection. p. 11
  4. -Check if cable is open. (Ref. Service Tip #060-Compressor Check and/or "Fan Motor Error" under "Compressor Control / Compressor Location Error" Type In Zendesk Help Center) p. 11

If 95 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Fujitsu General service.

Open the manual at page 11 All 410A error codes Manual details & download

This page summarises what the manufacturer’s manual says about 95; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Fujitsu General. Found a mistake? Report an error.