An open wiring problem in the RTD sensor probe circuit has been detected, possibly causing runaway oven conditions. The manual's first action is: “- Check wiring in probe circuit for possible open condition. - Check RTD resistance at room temperature (compare to probe resistance chart). If resistance does not match the chart, replace the RTD sensor probe.”
- Model
- Frigidaire Gallery Series Professional Series
- Display shows
- F30
- Type
- Fault code
- Source
- Manual p. 6
What F30 means
Open RTD sensor probe wiring problem. Note: EOC may initially display an "F" or thinking a runaway condition exists. p. 6
Common causes
- Open RTD sensor probe wiring problem. Note: EOC may initially display an "F" or thinking a runaway condition exists. p. 6
What to do
- - Check wiring in probe circuit for possible open condition. - Check RTD resistance at room temperature (compare to probe resistance chart). If resistance does not match the chart, replace the RTD sensor probe. p. 6
If F30 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Frigidaire service.
This page summarises what the manufacturer’s manual says about F30; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Frigidaire. Found a mistake? Report an error.