A runaway oven condition has been detected, likely from a shorted control or faulty RTD sensor probe. The manual's first action is: “- Check RTD sensor probe and replace if necessary. If oven is overheating, disconnect power. Oven continues to overheat when power is reapplied, replace the EOC.”
- Model
- Frigidaire Gallery Series Professional Series
- Display shows
- F10
- Type
- Fault code
- Source
- Manual p. 6
What F10 means
Control has sensed a potential runaway oven condition. Control may have shorted to ground. RTD sensor probe may have a gone bad. p. 6
Common causes
- Control has sensed a potential runaway oven condition. Control may have shorted to ground. RTD sensor probe may have a gone bad. p. 6
What to do
- - Check RTD sensor probe and replace if necessary. If oven is overheating, disconnect power. Oven continues to overheat when power is reapplied, replace the EOC. p. 6
If F10 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Frigidaire service.
This page summarises what the manufacturer’s manual says about F10; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Frigidaire. Found a mistake? Report an error.