Frigidaire Gallery Series Professional Series Error Codes: List of 14 Codes and Their Meaning

This is the list of error, fault codes the Frigidaire manual gives for the Gallery Series Professional Series fridge freezer. Find your code below and open it for what the manual says about its causes and what to do.

Error codes from p. 5

Code	What it means	Page
`E013`	Bad EEPROM.	p. 5
`E014`	Loss of Display tail #0.	p. 5
`E015`	Loss of Keyboard "Ei".	p. 5

Fault codes from p. 6

Code	What it means	Page
`F10`	Control has sensed a potential runaway oven condition. Control may have shorted to ground. RTD sensor probe may have a gone bad.	p. 6
`F11`	Shorted Key: A key has been detected as pressed (for a long period) will be considered a shorted key alarm and will terminate all oven activity.	p. 6
`F13`	Control's internal checksum may have become corrupted	p. 6
`F14`	Disconnected keyboard cable	p. 6
`F15`	Controller self check failed	p. 6
`F20`	Control has detected a problem with the communication link with the FSFC.	p. 6
`F30`	Open RTD sensor probe wiring problem. Note: EOC may initially display an "F" or thinking a runaway condition exists.	p. 6
`F31`	Shorted RTD sensor probe / wiring problem	p. 6
`F62`	Missing zero cross signal	p. 6
`F90`	Door motor mechanism failure. The controller does not see the motor rotating.	p. 6
`F95`	Door motor mechanism failure. The motor does not stop rotating	p. 6

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with Frigidaire. Found a mistake? Report an error.