FAGOR MAN REGUL (IN) Error 801: Encoder undetected

FAGOR MAN REGUL (IN) servo-drive system · taken from the manufacturer’s manual, pages cited

Error code801

Encoder undetected because GP2 is set to "0" (sinewave encoder) but a Resolver is actually installed. The manual's first action is: “The value of GP2 must be consistent with the feedback device installed. Contact Fagor Automation.”

Model
FAGOR MAN REGUL (IN)
Display shows
Encoder undetected (801)
Type
Error code
Source
Manual p. 332

What 801 means

Encoder undetected p. 332

Common causes

  • Parameter GP2 has been set to "0" (sinewave encoder) and the motor feedback is actually a Resolver. p. 332

What to do

  1. The value of GP2 must be consistent with the feedback device installed. Contact Fagor Automation. p. 332

If 801 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.

Open the manual at page 332 All MAN REGUL (IN) error codes Manual details & download

This page summarises what the manufacturer’s manual says about 801; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.