Danfoss 100 FLOW Error ID 648: System Fault

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 648

System Fault occurs due to operation malfunction or incompatible system software with application. The manual's first action is: “Reset the fault and restart.”

Model
Danfoss 100 FLOW
Display shows
System Fault (ID 648)
Type
Fault code
Source
Manual p. 297

What ID 648 means

System Fault p. 297

Common causes

  • Operation malfunction. p. 297
  • The system software is not compatible with the application. p. 297

What to do

  1. Reset the fault and restart. p. 297
  2. Download the latest software from the Danfoss Drives website. Update the drive with it. p. 297
  3. If the fault occurs again, ask for instructions from your nearest distributor. p. 297

If ID 648 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 297 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 648; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.