Danfoss 100 FLOW Error 45: Device Added (Different Type)

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code45

Device Added (Different Type) occurs when a new option board in slot E has no saved parameters. The manual's first action is: “Set the option board parameters again.”

Model
Danfoss 100 FLOW
Display shows
Device Added (Different Type) (45)
Type
Fault code
Source
Manual p. 309

What 45 means

Device Added (Different Type) p. 309

Common causes

  • A new option board, that you have not used before in the same slot, was put in slot E. No parameter settings are saved. p. 309

What to do

  1. Set the option board parameters again. p. 309

If 45 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 309 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 45; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.